Merge branch 'i2c/for-3.19' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux

Pull i2c updates from Wolfram Sang:
 "For 3.19, the I2C subsystem has to offer special candy this time.
  Right in time for Christmas :)

   - I2C slave framework: finally, a generic mechanism for Linux being
     an I2C slave (if the bus driver supports that).  Docs are still
     missing but will come later this cycle, the code is good enough to
     go.
   - I2C muxes represent their topology in sysfs much more detailed.
     This will help users to navigate around much easier.
   - irq population of i2c clients is now done at probe time, not device
     creation time, to have better support for deferred probing.
   - new drivers for Imagination SCB, Amlogic Meson
   - DMA support added for Freescale IMX, Renesas SHMobile
   - slightly bigger driver updates to OMAP, i801, AT91, and rk3x
     (mostly quirk handling, timing updates, and using better kernel
     interfaces)
   - eeprom driver can now write with byte-access (very slow, but OK to
     have)
   - and the bunch of smaller fixes, cleanups, ID updates..."

* 'i2c/for-3.19' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux: (56 commits)
  i2c: sh_mobile: remove unneeded DMA mask
  i2c: rcar: add slave support
  i2c: slave-eeprom: add eeprom simulator driver
  i2c: core changes for slave support
  MAINTAINERS: add I2C dt bindings also to I2C realm
  i2c: designware: Fix falling time bindings doc
  i2c: davinci: switch to use platform_get_irq
  Documentation: i2c: Use PM ops instead of legacy suspend/resume
  i2c: sh_mobile: optimize irq entry
  i2c: pxa: add support for SCCB devices
  omap: i2c: don't check bus state IP rev3.3 and earlier
  i2c: s3c2410: Handle i2c sys_cfg register in i2c driver
  i2c: rk3x: add Kconfig dependency on COMMON_CLK
  i2c: omap: add notes related to i2c multimaster mode
  i2c: omap: don't reset controller if Arbitration Lost detected
  i2c: omap: implement workaround for handling invalid BB-bit values
  i2c: omap: cleanup register definitions
  i2c: rk3x: handle dynamic clock rate changes correctly
  i2c: at91: enable probe deferring on dma channel request
  i2c: at91: remove legacy DMA support
  ...

include/linux/i2c.h

@@ -46,6 +46,8 @@ struct i2c_client;
 struct i2c_driver;
 union i2c_smbus_data;
 struct i2c_board_info;
+enum i2c_slave_event;
+typedef int (*i2c_slave_cb_t)(struct i2c_client *, enum i2c_slave_event, u8 *);
 
 struct module;
 
@@ -209,6 +211,8 @@ struct i2c_driver {
  * @irq: indicates the IRQ generated by this device (if any)
  * @detected: member of an i2c_driver.clients list or i2c-core's
  *	userspace_devices list
+ * @slave_cb: Callback when I2C slave mode of an adapter is used. The adapter
+ *	calls it to pass on slave events to the slave driver.
  *
  * An i2c_client identifies a single device (i.e. chip) connected to an
  * i2c bus. The behaviour exposed to Linux is defined by the driver
@@ -224,6 +228,7 @@ struct i2c_client {
 	struct device dev;		/* the device structure		*/
 	int irq;			/* irq issued by device		*/
 	struct list_head detected;
+	i2c_slave_cb_t slave_cb;	/* callback for slave mode	*/
 };
 #define to_i2c_client(d) container_of(d, struct i2c_client, dev)
 
@@ -246,6 +251,25 @@ static inline void i2c_set_clientdata(struct i2c_client *dev, void *data)
 	dev_set_drvdata(&dev->dev, data);
 }
 
+/* I2C slave support */
+
+enum i2c_slave_event {
+	I2C_SLAVE_REQ_READ_START,
+	I2C_SLAVE_REQ_READ_END,
+	I2C_SLAVE_REQ_WRITE_START,
+	I2C_SLAVE_REQ_WRITE_END,
+	I2C_SLAVE_STOP,
+};
+
+extern int i2c_slave_register(struct i2c_client *client, i2c_slave_cb_t slave_cb);
+extern int i2c_slave_unregister(struct i2c_client *client);
+
+static inline int i2c_slave_event(struct i2c_client *client,
+				  enum i2c_slave_event event, u8 *val)
+{
+	return client->slave_cb(client, event, val);
+}
+
 /**
  * struct i2c_board_info - template for device creation
  * @type: chip type, to initialize i2c_client.name
@@ -352,6 +376,8 @@ i2c_register_board_info(int busnum, struct i2c_board_info const *info,
  *   into I2C transfers instead.
  * @functionality: Return the flags that this algorithm/adapter pair supports
  *   from the I2C_FUNC_* flags.
+ * @reg_slave: Register given client to I2C slave mode of this adapter
+ * @unreg_slave: Unregister given client from I2C slave mode of this adapter
  *
  * The following structs are for those who like to implement new bus drivers:
  * i2c_algorithm is the interface to a class of hardware solutions which can
@@ -377,6 +403,9 @@ struct i2c_algorithm {
 
 	/* To determine what the adapter supports */
 	u32 (*functionality) (struct i2c_adapter *);
+
+	int (*reg_slave)(struct i2c_client *client);
+	int (*unreg_slave)(struct i2c_client *client);
 };
 
 /**