Merge git://git.denx.de/u-boot-usb

This commit is contained in:
Tom Rini 2014-08-29 11:15:18 -04:00
commit 8f005b3918
2 changed files with 25 additions and 5 deletions

View file

@ -34,7 +34,7 @@
#include <asm/byteorder.h>
#include <asm/unaligned.h>
#include <compiler.h>
#include <errno.h>
#include <usb.h>
#ifdef CONFIG_4xx
#include <asm/4xx_pci.h>
@ -60,6 +60,7 @@ int usb_init(void)
void *ctrl;
struct usb_device *dev;
int i, start_index = 0;
int ret;
dev_index = 0;
asynch_allowed = 1;
@ -75,7 +76,13 @@ int usb_init(void)
for (i = 0; i < CONFIG_USB_MAX_CONTROLLER_COUNT; i++) {
/* init low_level USB */
printf("USB%d: ", i);
if (usb_lowlevel_init(i, USB_INIT_HOST, &ctrl)) {
ret = usb_lowlevel_init(i, USB_INIT_HOST, &ctrl);
if (ret == -ENODEV) { /* No such device. */
puts("Port not available.\n");
continue;
}
if (ret) { /* Other error. */
puts("lowlevel init failed\n");
continue;
}

View file

@ -209,9 +209,22 @@ int hub_port_reset(struct usb_device *dev, int port,
(portstatus & USB_PORT_STAT_CONNECTION) ? 1 : 0,
(portstatus & USB_PORT_STAT_ENABLE) ? 1 : 0);
if ((portchange & USB_PORT_STAT_C_CONNECTION) ||
!(portstatus & USB_PORT_STAT_CONNECTION))
return -1;
/*
* Perhaps we should check for the following here:
* - C_CONNECTION hasn't been set.
* - CONNECTION is still set.
*
* Doing so would ensure that the device is still connected
* to the bus, and hasn't been unplugged or replaced while the
* USB bus reset was going on.
*
* However, if we do that, then (at least) a San Disk Ultra
* USB 3.0 16GB device fails to reset on (at least) an NVIDIA
* Tegra Jetson TK1 board. For some reason, the device appears
* to briefly drop off the bus when this second bus reset is
* executed, yet if we retry this loop, it'll eventually come
* back after another reset or two.
*/
if (portstatus & USB_PORT_STAT_ENABLE)
break;